As a 3-Axis short tail type carbide circular saw, the high-speed carbide circular saw KCS-100A with the tail length is only 20～20+α(cutting length), greatly save material and save processing time, compared with 2-Axis series which only have two servo motors, the feeding servo motor, the cutting servo motor, this type has the 3rd servo motor which in front of the main clamping device, through the 3rd servo motor, it clamped the material and pull out, till the cutting length, which ramains a short tail behind.
| Model/Specification | KCS-150A | |
| Cutting Capacity | Round | Φ 40-150 mm |
| Square | Φ 40-120 mm | |
| TCT Saw Blade | Blade Size | Φ 460*2.7T |
| Pin hole size | 4*Φ16*PCD80*Φ50 mm | |
| Rotating speed | 18-150 rpm | |
| Length accuracy | +/-0.1 mm | |
| Chip clean | Steel Brush | |
| Motor Power | Spindle motor | 15kw/6P |
| Hydraulic motor | 3.75 kw | |
| Cutting servo motor | 3.5 kw | |
| Feeding servo motor | 2.0 kw | |
| Chip conveyor motor | 0.2 kw | |
| Coolant pump motor | 0.19 kw | |
| Hydraulic | Hydraulic pressure | 90 kg/m² (9mpa) |
| Fuel tank volume | 110 L | |
| Pneumatic | Air pressure | 4-6 kg/m² (0.4-0.6mpa) |
| Feeding & Clamping | Feeding length | 10～800 mm |
| Tailing Length | 20～20+α(cutting length) | |
| Feeding drive mode | AC servo motor + ball screw + linear guide | |
| Clamping mode | Horizontal clamping & Vertical clamping | |
| Electricity | Voltage & Hertz | 3Phase, 380V, 50Hz or customized |
| Size & Weight | Floor Size | 7300*3100*2000mm |
| Weight | 6200kg | |
Contact us if you have any questions we will reply as soon aspossible
